Hardware Comparison

Following tables give a quick overview about all hardware available from HALaser Systems. This includes an overview about all electronics and control boards. To check out which controller cards are supported by BeamConstruct laser marking software, please go to page of supported hardware.

E1803D
E1701A
E1701D
E1701M
Type Compact Digital XY2/100 Scanner and Laser Controller Modular Analogue Scanner and Laser Controller Modular Digital XY2/100 Scanner and Laser Controller Motor Controller
Controllable Devices / Interfaces
  • XY2/100 Scanhead
  • Laser
  • Stepper Motors (requires power driver)
  • RS232/RS485
  • Stepper Motors (requires power driver)
Interface to Scanhead
XY2/100 (digital) D-SUB25 and 26 pin

±2,5..10 V (analogue)

XY2/100 (digital) 26 pin
Secondary Scanhead
Up to three via Secondary Head Extension Board
Interface to Laser
may require extension boards

may require extension boards
Motion Axes
up to four independent axes via integrated digital IOs

up to four independent axes via Digi I/O Extension Board

up to four independent axes via Digi I/O Extension Board

up to four independent axes
Expandable by Extension Boards
Supports stand-alone operation
manual jog-mode
Supports marking on-the-fly
requires Digi I/O Extension Board

requires Digi I/O Extension Board
BeamConstruct PRO License included
Power Supply ±12..24 V or USB ±15 V +5 V or USB +5 V or USB
SLS/3D Printing (Rapid Prototyping)
Laser via scanhead

Laser via scanhead

Laser via scanhead
Dot-Peen / Matrix Laser Marking
1..2 lines, 6..13 dots
Price
plus shipping, optionally plus VAT, non-binding price, subject to change or errors, discount may be included, ask for conditions and quotation!
544,00 Euro 300,00 Euro
optionally plus extension board(s)
271,00 Euro
optionally plus extension board(s)
262,00 Euro
Detailled Information Click here! Click here! Click here! Click here!